General Question G5C02
G5C: Resistors, capacitors, and inductors in series and parallel; transformers
What is the output voltage if an input signal is applied to the secondary winding of a 4:1 voltage step-down transformer instead of the primary winding?
- The input voltage is multiplied by 4 (correct answer)
- The input voltage is divided by 4
- Additional resistance must be added in series with the primary to prevent overload
- Additional resistance must be added in parallel with the secondary to prevent overload
Correct answer: A, The input voltage is multiplied by 4
Explanation
A transformer works in either direction, and its voltage ratio follows the turns ratio. A 4:1 step-down transformer has four times as many turns on its primary as on its secondary. If you drive the secondary instead, the transformer acts as a 1:4 step-up, so the output voltage is four times the input. The current changes the opposite way, dropping to one quarter.
Why the other answers are wrong
- B, The input voltage is divided by 4: Dividing by 4 is what happens in the normal direction, primary in and secondary out. Reversing the connections reverses the ratio.
- C, Additional resistance must be added in series with the primary to prevent overload: No series resistor is needed. The transformer simply operates as a step-up, as long as its voltage ratings aren't exceeded.
- D, Additional resistance must be added in parallel with the secondary to prevent overload: A parallel resistor across the secondary would just waste power. Reversing a transformer doesn't create an overload that a resistor must fix.