General Question G6B04
G6B: Analog and digital integrated circuits (ICs); microwave ICs (MMICs); display devices; RF connectors; ferrite cores
What is a typical upper frequency limit for low SWR operation of 50-ohm BNC connectors?
- 50 MHz
- 500 MHz
- 4 GHz (correct answer)
- 40 GHz
Correct answer: C, 4 GHz
Explanation
A 50-ohm BNC connector holds a fairly constant impedance through its bayonet joint, so it keeps SWR low well past VHF and UHF. Its typical practical upper limit is around 4 GHz. Above that, small discontinuities in its geometry cause reflections, and threaded connectors such as SMA or Type N are used instead.
Why the other answers are wrong
- A, 50 MHz: 50 MHz is far too low; BNC connectors are routinely used on 2 meters, 70 cm and well beyond with good SWR.
- B, 500 MHz: 500 MHz badly undersells a BNC; even non-constant-impedance UHF-series (PL-259/SO-239) connectors are typically rated only to about 300 MHz.
- D, 40 GHz: 40 GHz requires precision connectors such as 2.92 mm types; a BNC's bayonet geometry can't hold a constant impedance that high.