General Question G8A01
G8A: Carriers and modulation: AM, FM, and single sideband; modulation envelope; digital modulation; overmodulation; link budgets and link margins
How is direct binary FSK modulation generated?
- By keying an FM transmitter with a sub-audible tone
- By changing an oscillator’s frequency directly with a digital control signal (correct answer)
- By using a transceiver’s computer data interface protocol to change frequencies
- By reconfiguring the CW keying input to act as a tone generator
Correct answer: B, By changing an oscillator’s frequency directly with a digital control signal
Explanation
In direct binary FSK, the digital data line shifts the transmitter oscillator itself between two frequencies, one for mark and one for space. This differs from AFSK, where audio tones feed an SSB or FM transmitter's audio input. On HF RTTY, direct FSK typically produces a 170 Hz shift between the two RF frequencies.
Why the other answers are wrong
- A, By keying an FM transmitter with a sub-audible tone: A sub-audible tone keyed into an FM transmitter describes CTCSS access tones, not frequency-shift keying of data.
- C, By using a transceiver’s computer data interface protocol to change frequencies: A computer control interface such as CAT changes the operating frequency for tuning, too slowly to key data bits.
- D, By reconfiguring the CW keying input to act as a tone generator: The CW keying input turns the carrier on and off and does not generate tones; FSK shifts frequency instead.