General Question G8B09
G8B: Frequency changing; bandwidths of various modes; deviation; intermodulation
Why is it good to match receiver bandwidth to the bandwidth of the operating mode?
- It is required by FCC rules
- It minimizes power consumption in the receiver
- It improves impedance matching of the antenna
- It results in the best signal-to-noise ratio (correct answer)
Correct answer: D, It results in the best signal-to-noise ratio
Explanation
Received noise power rises with bandwidth. A filter much wider than the signal lets in extra noise and nearby interference while adding nothing to the desired signal. One narrower than the signal cuts off part of the signal itself. Matching the filter to the mode, such as about 500 Hz for CW or 2.4 kHz for SSB, gives the best signal-to-noise ratio.
Why the other answers are wrong
- A, It is required by FCC rules: FCC rules regulate transmitted emissions, not your receiver's filter settings. Choosing the receive bandwidth is up to the operator.
- B, It minimizes power consumption in the receiver: Changing IF or DSP filter bandwidth has essentially no effect on the receiver's power draw.
- C, It improves impedance matching of the antenna: Antenna impedance matching depends on the antenna, feed line and tuner. The receiver's IF filter bandwidth does not change it.