General Question G9A01
G9A: Feed lines: characteristic impedance and attenuation; standing wave ratio (SWR) calculation, measurement, and effects; antenna feed point matching
Which of the following factors determine the characteristic impedance of a parallel conductor feed line?
- The distance between the centers of the conductors and the radius of the conductors (correct answer)
- The distance between the centers of the conductors and the length of the line
- The radius of the conductors and the frequency of the signal
- The frequency of the signal and the length of the line
Correct answer: A, The distance between the centers of the conductors and the radius of the conductors
Explanation
The characteristic impedance of any feed line depends on its physical geometry and the insulation between the conductors. For parallel-conductor line, impedance rises as the conductors move farther apart, and falls as the conductors get thicker. Approximately, Z0 = 276 log10(2D/d) ohms, where D is center spacing and d is conductor diameter. Line length and frequency don't change Z0.
Why the other answers are wrong
- B, The distance between the centers of the conductors and the length of the line: Spacing matters, but length does not; Z0 is the same for a 1 m piece as for a 100 m piece of the same line.
- C, The radius of the conductors and the frequency of the signal: Conductor size matters, but characteristic impedance is essentially independent of frequency.
- D, The frequency of the signal and the length of the line: Neither frequency nor length sets Z0; they affect loss and the impedance seen at the line input, not the line's characteristic impedance.