General Question G9B02
G9B: Basic dipole and monopole antennas
Which of the following is a common way to adjust the feed point impedance of an elevated quarter-wave ground-plane vertical antenna to be approximately 50 ohms?
- Slope the radials upward
- Slope the radials downward (correct answer)
- Lengthen the radials beyond one wavelength
- Coil the radials
Correct answer: B, Slope the radials downward
Explanation
A quarter-wave vertical with horizontal radials has a feed point impedance of about 35-36 ohms. Bending the radials downward, typically about 45 degrees, raises the impedance to about 50 ohms for a direct coax match. Bending them fully downward would turn the antenna into a vertical dipole of about 73 ohms.
Why the other answers are wrong
- A, Slope the radials upward: Sloping the radials upward moves the impedance the wrong way, lowering it below the roughly 36 ohms of horizontal radials.
- C, Lengthen the radials beyond one wavelength: Elevated radials are cut near a quarter wavelength for resonance; making them longer than a wavelength detunes the system rather than setting 50 ohms.
- D, Coil the radials: Coiling adds inductance, which shortens or loads radials and shifts resonance; it isn't the standard way to raise the impedance to 50 ohms.