General Question G9D02
G9D: Specialized antenna types and applications
What is the feed point impedance of an end-fed half-wave antenna?
- Very low
- Approximately 50 ohms
- Approximately 300 ohms
- Very high (correct answer)
Correct answer: D, Very high
Explanation
On a half-wave element the current is greatest at the center and falls to nearly zero at the ends, while voltage peaks at the ends. Impedance is voltage divided by current, so the end feed point shows a very high impedance, typically a few thousand ohms. End-fed half-wave antennas therefore use a step-up transformer (often about 49:1) or a tuned matching network to reach 50 Ω.
Why the other answers are wrong
- A, Very low: Very low impedance is found where current is maximum, at the center of a half-wave element, not at its end.
- B, Approximately 50 ohms: Roughly 50 to 75 Ω is the center feed impedance of a half-wave dipole, not the end-fed value.
- C, Approximately 300 ohms: About 300 Ω is typical of a folded dipole at its center, still far below the thousands of ohms at a half-wave end.