Technician Question T4A08
T4A: Station setup: connecting a microphone, RF power meter, a power source, a computer, digital equipment, an SWR meter; bonding; Mobile radio installation
Which of the following conductors is preferred for bonding at RF?
- Copper braid removed from coaxial cable
- Copper-clad steel wire
- Twisted-pair cable
- Flat copper strap (correct answer)
Correct answer: D, Flat copper strap
Explanation
At RF, current flows on a conductor's surface (skin effect), and even short bonding leads have inductance that raises their impedance. A wide, flat copper strap has a large surface area and low inductance, so it keeps equipment at the same RF potential. That reduces RF in the shack, hum and stray voltages better than round wire of similar weight.
Why the other answers are wrong
- A, Copper braid removed from coaxial cable: Coax braid is made of many fine strands that corrode and loosen over time, so its resistance rises; it's a poor substitute for solid strap.
- B, Copper-clad steel wire: Copper-clad steel is a narrow round wire with more inductance than wide strap, so it bonds less effectively at RF.
- C, Twisted-pair cable: Twisted-pair conductors are thin, high in inductance and meant for signals, not low-impedance RF bonding.