Technician Question T4B10
T4B: Operating controls: frequency tuning, use of filters, squelch function, AGC, memory channels, noise blanker, microphone gain, receiver incremental tuning (RIT), bandwidth selection, scanning function; Digital transceiver configuration; DMR code plugs and talk groups
Which of the following receiver filter bandwidths provides the best signal-to-noise ratio for SSB reception?
- 500 Hz
- 1000 Hz
- 2400 Hz (correct answer)
- 5000 Hz
Correct answer: C, 2400 Hz
Explanation
An SSB voice signal covers roughly 300 Hz to 2700 Hz of audio, about 2.4 kHz wide. A 2400 Hz filter passes nearly all of that energy while keeping out noise beyond the signal's edges. That gives the best signal-to-noise ratio for this mode. The general rule is to match the filter to the signal's bandwidth.
Why the other answers are wrong
- A, 500 Hz: 500 Hz suits CW; on SSB it would cut off most of the voice energy, making speech muffled or unintelligible.
- B, 1000 Hz: 1000 Hz still removes much of the speech band, so audio quality and readability suffer even though noise is lower.
- D, 5000 Hz: 5000 Hz is roughly twice an SSB signal's width; it fits AM, but on SSB it adds noise and adjacent-signal interference with no gain.