Technician Question T7B02
T7B: Symptoms, causes, and cures of common transmitter and receiver problems: overload and overdrive, distortion, interference and consumer electronics, RF feedback
What would cause a broadcast AM or FM radio to receive an amateur radio transmission unintentionally?
- The receiver is unable to reject strong signals outside the AM or FM band (correct answer)
- The microphone gain of the transmitter is turned up too high
- The audio amplifier of the transmitter is overloaded
- The deviation of an FM transmitter is set too low
Correct answer: A, The receiver is unable to reject strong signals outside the AM or FM band
Explanation
A nearby amateur signal can be very strong even when it is well outside the broadcast band. A consumer receiver with poor selectivity or a weak front end cannot reject it, so the signal overloads the receiver and gets heard. This is called fundamental overload. The fault lies in the receiver's design, not the transmitter, and the usual cure is a filter at the affected receiver.
Why the other answers are wrong
- B, The microphone gain of the transmitter is turned up too high: High mic gain distorts the amateur's own audio, but it does not explain why a broadcast set picks up an out-of-band signal.
- C, The audio amplifier of the transmitter is overloaded: An overloaded transmitter audio stage causes distortion on the ham signal itself, not reception by an unrelated broadcast receiver.
- D, The deviation of an FM transmitter is set too low: Low FM deviation only makes the ham signal sound quiet; it does not cause broadcast receivers to pick it up.