Technician Question T7B05
T7B: Symptoms, causes, and cures of common transmitter and receiver problems: overload and overdrive, distortion, interference and consumer electronics, RF feedback
Which of the following might reduce interference by an amateur station to a non-amateur over-the-air radio receiver?
- Block the amateur signal with a filter at the antenna input of the affected receiver (correct answer)
- Block the interfering signal with a filter on the amateur transmitter
- Switch the transmitter from FM to SSB
- Switch the transmitter to a narrow-band mode
Correct answer: A, Block the amateur signal with a filter at the antenna input of the affected receiver
Explanation
When the ham signal is clean and the receiver is simply overloaded by it, the cure belongs at the receiver. A filter at the receiver's antenna input lets the wanted band pass through, such as an FM broadcast or TV channel, while blocking the strong amateur signal before it reaches the front end. A common example is a high-pass filter on a TV antenna input.
Why the other answers are wrong
- B, Block the interfering signal with a filter on the amateur transmitter: A filter at the transmitter removes harmonics and spurs, but it cannot remove your fundamental signal, which is what overloads the receiver.
- C, Switch the transmitter from FM to SSB: Changing from FM to SSB does not cure overload; a strong signal on your operating frequency still swamps a poorly designed receiver.
- D, Switch the transmitter to a narrow-band mode: Narrowing bandwidth does not reduce the signal's strength at the neighbor's receiver, so overload continues.