Technician Question T7B09
T7B: Symptoms, causes, and cures of common transmitter and receiver problems: overload and overdrive, distortion, interference and consumer electronics, RF feedback
What should be the first step to resolve non-fiber optic cable TV interference caused by your amateur radio transmission?
- Add a low-pass filter to the TV antenna input
- Add a high-pass filter to the TV antenna input
- Add a preamplifier to the TV antenna input
- Be sure all TV feed line coaxial connectors are installed properly (correct answer)
Correct answer: D, Be sure all TV feed line coaxial connectors are installed properly
Explanation
A cable TV system is supposed to be a closed, shielded path. Loose, corroded or poorly installed coax connectors break that shield, so your RF can leak into the cable (ingress). Making sure every connector is properly installed and tight is the simplest first step. It often cures the problem without any filters.
Why the other answers are wrong
- A, Add a low-pass filter to the TV antenna input: A low-pass filter belongs on the transmitter output to cut harmonics, and on a TV input it would block the TV channels themselves.
- B, Add a high-pass filter to the TV antenna input: A high-pass filter can help in some cases, but it is a later step; first make sure faulty connectors are not letting RF in.
- C, Add a preamplifier to the TV antenna input: A preamplifier amplifies the interfering signal too and typically makes overload interference worse.