Element 3 Question 3-42F3
C3F42: RF Amplifiers
How much gain should be used in the RF amplifier stage of a receiver?
- Sufficient gain to allow weak signals to overcome noise generated in the first mixer stage. (correct answer)
- As much gain as possible short of self oscillation.
- Sufficient gain to keep weak signals below the noise of the first mixer stage.
- It depends on the amplification factor of the first IF stage.
Correct answer: A, Sufficient gain to allow weak signals to overcome noise generated in the first mixer stage.
Explanation
The RF amplifier's job is to raise weak signals above the noise the first mixer adds. Mixers are noisy, and by the Friis formula the first stage's gain divides the noise contribution of every later stage. Once the RF gain is high enough that mixer noise no longer matters, more gain adds nothing to sensitivity. It only pushes strong signals into overload and intermodulation.
Why the other answers are wrong
- B, As much gain as possible short of self oscillation.: Maximum gain overloads the mixer with strong signals and causes intermodulation; gain beyond what overcomes mixer noise brings no sensitivity benefit.
- C, Sufficient gain to keep weak signals below the noise of the first mixer stage.: This is backwards: keeping weak signals below mixer noise would bury them, which defeats the purpose of having an RF amplifier at all.
- D, It depends on the amplification factor of the first IF stage.: RF stage gain is set by the noise of the stage right after it, the first mixer, not by the IF amplifier further down the chain.