Element 8 Question 8-23C3
C8C23: Detectors - Video Amplifiers
In video amplifiers, compensation for the input and output stage capacitances must be accomplished to prevent distorting the video pulses. This compensation is normally accomplished by connecting:
- Inductors in parallel with both the input and output capacitances.
- Resistances in parallel with both the input and output capacitances.
- An inductor in parallel with the input capacitance and an inductor in series with the output capacitance.
- An inductor in series with the input capacitance and an inductor in parallel with the output capacitance. (correct answer)
Correct answer: D, An inductor in series with the input capacitance and an inductor in parallel with the output capacitance.
Explanation
This is series-and-shunt peaking. A small coil in series between stages isolates the next stage's input capacitance from the previous stage's output. A coil in the shunt load branch forms a low-Q resonance with the output capacitance. Both coils lift the response where those capacitances would otherwise roll off high frequencies, which keeps pulse edges sharp and pulse tops flat.
Why the other answers are wrong
- A, Inductors in parallel with both the input and output capacitances.: A coil directly across the input capacitance does not give series peaking. The input side needs a series inductor to isolate and peak that capacitance.
- B, Resistances in parallel with both the input and output capacitances.: Resistors cannot resonate with capacitance to extend the high-frequency response. Placing them across the capacitances only lowers gain.
- C, An inductor in parallel with the input capacitance and an inductor in series with the output capacitance.: This swaps the arrangement. Series peaking acts on the input capacitance and shunt peaking acts on the output capacitance, not the other way around.