Element 8 Question 8-43E1
C8E43: Waveguides-2
A rotary joint is used to:
- Couple two waveguides together at right angles.
- Act as a switch between two waveguide runs.
- Connect a stationary waveguide to the antenna array. (correct answer)
- Maintain pressurization at the end of the waveguide.
Correct answer: C, Connect a stationary waveguide to the antenna array.
Explanation
A ship radar antenna turns continuously while the transceiver and its waveguide run stay fixed. The rotary joint sits at the base of the scanner. It lets the antenna side spin freely while keeping a low-loss RF path from the stationary waveguide. Inside, it usually converts to a circularly symmetric mode so the signal is unaffected by rotation.
Why the other answers are wrong
- A, Couple two waveguides together at right angles.: Joining guides at right angles is done with an E-plane or H-plane bend or elbow, not a rotary joint.
- B, Act as a switch between two waveguide runs.: Switching between waveguide runs uses a waveguide switch or a duplexer/circulator; a rotary joint does not select paths.
- D, Maintain pressurization at the end of the waveguide.: Pressurization is held by sealed windows and the dry-air system. The rotary joint's job is to pass RF through a rotating connection.