Element 8 Question 8-43E3
C8E43: Waveguides-2
A right-angle bend in an X-band waveguide must have a radius greater than:
- Three inches.
- Six inches.
- One inch.
- Two inches. (correct answer)
Correct answer: D, Two inches.
Explanation
A sharp waveguide bend causes reflections, which raise the SWR and can lead to arcing. A common rule of thumb is a bend radius of at least about two wavelengths. At X-band (about 9.4 GHz) the wavelength is about 3.2 cm, so two wavelengths is about 6.4 cm, or roughly 2.5 in. A right-angle bend in X-band guide therefore needs a radius greater than two inches.
Why the other answers are wrong
- A, Three inches.: Three inches is safe but more than required. Two X-band wavelengths come to only about 2.5 in, so the minimum is about two inches.
- B, Six inches.: Six inches is far more than X-band needs, since two wavelengths of about 3.2 cm come to only about 6.4 cm, roughly 2.5 in.
- C, One inch.: One inch is less than one X-band wavelength (about 3.2 cm), so a bend that tight would cause reflections and a high SWR.