Element 8 Question 8-49F5
C8F49: Installation
In a RADAR system, wave guides should be installed
- Slightly bent for maximum gain.
- As straight as possible to reduce distortion. (correct answer)
- At 90 degree angles to improve resonance.
- As long as possible for system flexibility.
Correct answer: B, As straight as possible to reduce distortion.
Explanation
Every bend, twist or joint in a waveguide is a discontinuity. Each one adds loss and reflections (higher VSWR) and can disturb the propagating mode, which degrades the transmitted pulse and the weak echoes. Install the run as straight and short as practical. Where a bend is needed, use a proper E-plane or H-plane bend with the correct radius, never a field-bent section.
Why the other answers are wrong
- A, Slightly bent for maximum gain.: Bending a waveguide never adds gain. Kinks or improvised bends deform the cross-section and add loss and reflections.
- C, At 90 degree angles to improve resonance.: Sharp 90 degree turns create reflections. A transmission line should carry energy cleanly, not resonate.
- D, As long as possible for system flexibility.: Extra length only adds attenuation of both the outgoing pulse and the returning echoes. The run should be as short as practical.