Amateur Extra Question E4A06
E4A: Test equipment: analog and digital instruments; spectrum analyzers; antenna analyzers; oscilloscopes; RF measurements
What is the effect of aliasing on a digital oscilloscope when displaying a waveform?
- A false, jittery low-frequency version of the waveform is displayed (correct answer)
- The waveform DC offset will be inaccurate
- Calibration of the vertical scale is no longer valid
- Excessive blanking occurs, which prevents display of the waveform
Correct answer: A, A false, jittery low-frequency version of the waveform is displayed
Explanation
Aliasing happens when the sample rate is less than twice the signal frequency. The samples then fit a lower-frequency waveform that is not actually there, so the scope shows a false low-frequency trace. Because the trigger cannot lock onto this phantom signal, the display often looks jittery or drifts. Raising the sample rate (a faster timebase setting) removes it.
Why the other answers are wrong
- B, The waveform DC offset will be inaccurate: Aliasing is a frequency effect from undersampling; it does not shift the DC offset.
- C, Calibration of the vertical scale is no longer valid: The amplitude scale stays calibrated; aliasing misrepresents frequency and shape, not the vertical calibration.
- D, Excessive blanking occurs, which prevents display of the waveform: Blanking is an analog CRT beam-retrace concept and is not what undersampling causes.