Amateur Extra Question E4A10
E4A: Test equipment: analog and digital instruments; spectrum analyzers; antenna analyzers; oscilloscopes; RF measurements
Which trigger mode is most effective when using an oscilloscope to measure a linear power supply’s output ripple?
- Single-shot
- Edge
- Level
- Line (correct answer)
Correct answer: D, Line
Explanation
Ripple on a linear supply comes from rectifying the AC line, so it repeats at 60 Hz for a half-wave rectifier or 120 Hz for a full-wave rectifier. Line triggering takes the sweep's timing reference from the scope's own AC power line, so the trace locks solidly to the ripple even when the ripple is small, noisy or irregular in shape.
Why the other answers are wrong
- A, Single-shot: Single-shot captures one event, such as a glitch, and does not give a steady, repeating view of continuous ripple.
- B, Edge: Edge triggering on the small, noisy ripple signal can be jittery and unreliable compared with syncing directly to the power line.
- C, Level: Level is a trigger setting, not the mode that syncs to the AC line, and setting it on a tiny ripple waveform gives an unstable display.