Amateur Extra Question E4C01
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is an effect of excessive phase noise in an SDR receiver’s master clock oscillator?
- It limits the receiver’s ability to receive strong signals
- It can affect the receiver’s frequency calibration
- It decreases the receiver’s third-order intercept point
- It can combine with strong signals on nearby frequencies to generate interference (correct answer)
Correct answer: D, It can combine with strong signals on nearby frequencies to generate interference
Explanation
Phase noise spreads a little of a clock's energy into noise sidebands on either side of its frequency. In an SDR, this noisy clock acts as the sampling or mixing reference. A strong signal near the one you want mixes with those sidebands and dumps noise into your passband. This is called reciprocal mixing, and it raises the noise floor near strong signals.
Why the other answers are wrong
- A, It limits the receiver’s ability to receive strong signals: Strong-signal limits come from ADC overload and front-end compression; phase noise causes interference near strong signals rather than blocking their reception.
- B, It can affect the receiver’s frequency calibration: Calibration depends on the oscillator's average frequency accuracy; phase noise is short-term jitter around that frequency, not an offset.
- C, It decreases the receiver’s third-order intercept point: Third-order intercept measures how linear the amplifiers and mixers are; clock phase noise does not change it.