Amateur Extra Question E4C02
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
Which of the following receiver circuits can be effective in eliminating interference from strong out-of-band signals?
- A front-end filter or preselector (correct answer)
- A narrow IF filter
- A notch filter
- A properly adjusted product detector
Correct answer: A, A front-end filter or preselector
Explanation
Strong signals outside the band you are using cause trouble when they reach the first amplifier, mixer or ADC. There they can overload the circuit, cause blocking, or create intermodulation products. A front-end filter or preselector, ahead of these stages, attenuates out-of-band energy before it can do harm. It is the only option that acts before the damage occurs.
Why the other answers are wrong
- B, A narrow IF filter: An IF filter comes after the mixer, so products from an overloaded front end are already formed and fall within the passband.
- C, A notch filter: A notch filter removes one narrow frequency, usually an in-band carrier, and cannot protect the front end from strong signals across other bands.
- D, A properly adjusted product detector: A product detector demodulates SSB and CW at the end of the signal chain; adjusting it does not stop overload in earlier stages.