Amateur Extra Question E4C03
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is the term for the suppression in an FM receiver of one signal by another stronger signal on the same frequency?
- Desensitization
- Cross-modulation interference
- Capture effect (correct answer)
- Frequency discrimination
Correct answer: C, Capture effect
Explanation
An FM receiver's limiter and discriminator respond mainly to the strongest signal present. When two FM signals share a frequency and one is noticeably stronger (often by only a few dB), the receiver locks onto it and the weaker one nearly disappears. This is the capture effect. It is why you may hear only the closer of two stations on the same channel, with the audio switching abruptly as their relative strengths change.
Why the other answers are wrong
- A, Desensitization: Desensitization is a loss of sensitivity when a strong signal on a nearby frequency overloads the front end, not one FM signal taking over another on the same frequency.
- B, Cross-modulation interference: Cross-modulation is when nonlinearity impresses a strong unwanted signal's modulation onto the desired signal, so both are heard; it does not suppress the weaker signal.
- D, Frequency discrimination: Frequency discrimination is how an FM detector converts frequency variations into audio, not the suppression of a weaker co-channel signal.