Amateur Extra Question E4C04
E4C: Receiver performance: phase noise, noise floor, image rejection, minimum detectable signal (MDS), increasing signal-to-noise ratio and dynamic range, noise figure, reciprocal mixing; selectivity; SDR non-linearity; use of attenuators at low frequencies
What is the noise figure of a receiver?
- The ratio of atmospheric noise to phase noise
- The ratio of the noise bandwidth in hertz to the theoretical bandwidth of a resistive network
- The ratio in dB of the noise generated in the receiver to atmospheric noise
- The ratio in dB of the noise generated by the receiver to the theoretical minimum noise (correct answer)
Correct answer: D, The ratio in dB of the noise generated by the receiver to the theoretical minimum noise
Explanation
Noise figure compares the noise a real receiver produces with that of an ideal, noiseless receiver, which would show only the unavoidable thermal noise of its input source. Expressed in dB, it tells you how much the receiver degrades signal-to-noise ratio. A 0 dB noise figure is perfect. A 3 dB figure means the receiver adds noise equal to the theoretical minimum, doubling the total.
Why the other answers are wrong
- A, The ratio of atmospheric noise to phase noise: Atmospheric noise comes from outside the receiver and phase noise comes from its oscillators; neither ratio describes the noise the whole receiver adds.
- B, The ratio of the noise bandwidth in hertz to the theoretical bandwidth of a resistive network: This confuses noise bandwidth with noise figure; noise figure compares noise power levels, not bandwidths.
- C, The ratio in dB of the noise generated in the receiver to atmospheric noise: Atmospheric noise is external and varies with band, time and location, so it can't serve as the fixed reference; the reference is the theoretical thermal minimum.