Amateur Extra Question E4D04
E4D: Receiver performance characteristics: dynamic range; intermodulation and cross-modulation interference; third-order intercept; desensitization; preselector; sensitivity; link margin
Which of the following is used to reduce or eliminate intermodulation interference in a repeater caused by a nearby transmitter?
- A band-pass filter in the feed line between the transmitter and receiver
- A properly terminated circulator at the output of the repeater’s transmitter (correct answer)
- Utilizing a Class C final amplifier
- Utilizing a Class D final amplifier
Correct answer: B, A properly terminated circulator at the output of the repeater’s transmitter
Explanation
A circulator (or isolator) passes RF forward from the transmitter to the antenna. Signal coming back in from the antenna, such as a nearby transmitter's signal, is routed into a dummy-load termination instead of the final amplifier. With the outside signal kept out of the final, the nonlinear mixing that creates intermodulation products cannot happen.
Why the other answers are wrong
- A, A band-pass filter in the feed line between the transmitter and receiver: Transmitter and receiver are not linked by a feed line that a band-pass filter would fix; the trouble is the outside signal reaching the transmitter's final.
- C, Utilizing a Class C final amplifier: A Class C amplifier is highly nonlinear, so it mixes incoming signals readily and makes intermodulation worse.
- D, Utilizing a Class D final amplifier: A Class D switching amplifier is also strongly nonlinear and would still mix any outside signal that reaches it.