Amateur Extra Question E4D10
E4D: Receiver performance characteristics: dynamic range; intermodulation and cross-modulation interference; third-order intercept; desensitization; preselector; sensitivity; link margin
What does a third-order intercept level of 40 dBm mean with respect to receiver performance?
- Signals less than 40 dBm will not generate audible third-order intermodulation products
- The receiver can tolerate signals up to 40 dB above the noise floor without producing third-order intermodulation products
- A pair of 40 dBm input signals will theoretically generate a third-order intermodulation product that has the same output amplitude as either of the input signals (correct answer)
- A pair of 1 mW input signals will produce a third-order intermodulation product that is 40 dB stronger than the input signal
Correct answer: C, A pair of 40 dBm input signals will theoretically generate a third-order intermodulation product that has the same output amplitude as either of the input signals
Explanation
Plot output against input. The desired signal rises 1 dB per dB of input, and the third-order product rises 3 dB per dB. If you extend both lines, they cross at the third-order intercept. An IP3 of +40 dBm (10 W) means two +40 dBm input tones would, in theory, produce a product as strong as either tone. Real receivers compress long before that, so the point is extrapolated. A higher IP3 means better strong-signal handling.
Why the other answers are wrong
- A, Signals less than 40 dBm will not generate audible third-order intermodulation products: Intermodulation products exist at every input level, just weaker; whether they are audible depends on the noise floor, not on staying below the intercept.
- B, The receiver can tolerate signals up to 40 dB above the noise floor without producing third-order intermodulation products: This confuses intercept with dynamic range; intercept is an absolute power in dBm, not a number of dB above the noise floor.
- D, A pair of 1 mW input signals will produce a third-order intermodulation product that is 40 dB stronger than the input signal: Products are always weaker than the inputs below the intercept; with 0 dBm tones and +40 dBm IP3, they are about 80 dB below the tones.