Amateur Extra Question E4E04
E4E: Noise and interference: external RF interference; electrical and computer noise; line noise; DSP filtering and noise reduction; common-mode current; surge protectors; single point ground panel
How can conducted noise from an automobile battery charging system be suppressed?
- By installing filter capacitors in series with the alternator leads
- By installing a noise suppression resistor and a blocking capacitor at the battery
- By installing a high-pass filter in series with the radio’s power lead and a low-pass filter in parallel with the antenna feed line
- By installing ferrite chokes on the charging system leads (correct answer)
Correct answer: D, By installing ferrite chokes on the charging system leads
Explanation
Alternator and regulator noise travels as RF current along the charging system wiring. A ferrite choke on these leads adds impedance at radio frequencies, while the DC charging current passes through almost unaffected. The noise is blocked before it spreads through the vehicle wiring to the radio. The general rule: chokes go in series with a lead, and bypass capacitors go in shunt to ground.
Why the other answers are wrong
- A, By installing filter capacitors in series with the alternator leads: A capacitor in series would block the alternator's DC output. Noise filter capacitors are connected in shunt (bypass) to ground, not in series.
- B, By installing a noise suppression resistor and a blocking capacitor at the battery: Suppression resistors are used in spark plug ignition leads, not at the battery. A blocking capacitor there does nothing useful for charging noise.
- C, By installing a high-pass filter in series with the radio’s power lead and a low-pass filter in parallel with the antenna feed line: A high-pass filter would block the radio's DC supply, and a low-pass filter is placed in series, not in parallel. The filter roles here are scrambled.