Amateur Extra Question E7B05
E7B: Amplifiers: class of operation; vacuum tube and solid-state circuits; distortion and intermodulation; spurious and parasitic suppression; switching-type amplifiers
What can be done to prevent unwanted oscillations in an RF power amplifier?
- Tune the stage for minimum loading
- Tune both the input and output for maximum power
- Install parasitic suppressors and/or neutralize the stage (correct answer)
- Use a phase inverter in the output filter
Correct answer: C, Install parasitic suppressors and/or neutralize the stage
Explanation
Parasitic suppressors are usually a small inductor in parallel with a resistor in the plate or grid lead. They add loss at VHF, damping parasitic oscillations without affecting the operating frequency. Neutralization feeds back a signal of opposite phase to cancel feedback through the device's internal capacitance, which could otherwise make the stage oscillate near its operating frequency.
Why the other answers are wrong
- A, Tune the stage for minimum loading: Minimum loading leaves the stage lightly loaded with high gain, which makes self-oscillation more likely, not less.
- B, Tune both the input and output for maximum power: Tuning for maximum power optimizes output at the desired frequency but does nothing to remove feedback paths or damp parasitic resonances.
- D, Use a phase inverter in the output filter: A phase inverter has no role in an output filter, and the filter sits after the stage, so it cannot stop oscillations generated inside it.