Amateur Extra Question E7B04
E7B: Amplifiers: class of operation; vacuum tube and solid-state circuits; distortion and intermodulation; spurious and parasitic suppression; switching-type amplifiers
What is the operating point of a Class A common emitter amplifier?
- Approximately halfway between saturation and cutoff (correct answer)
- Approximately halfway between the emitter voltage and the base voltage
- At a point where the bias resistor equals the load resistor
- At a point where the load line intersects the zero bias current curve
Correct answer: A, Approximately halfway between saturation and cutoff
Explanation
A Class A amplifier conducts for the full 360° of the input cycle. To do that, it is biased so the quiescent (Q) point sits near the middle of the load line, about halfway between saturation (fully on) and cutoff (fully off). The output can then swing equally up and down without clipping on either peak. This gives the best linearity, but low efficiency.
Why the other answers are wrong
- B, Approximately halfway between the emitter voltage and the base voltage: Base and emitter voltages differ by only about 0.6 V of junction drop, so a point halfway between them says nothing about where the transistor sits on its load line.
- C, At a point where the bias resistor equals the load resistor: Making the bias resistor equal the load resistor is not a biasing criterion; the Q point is set by where the bias current places the transistor on its load line.
- D, At a point where the load line intersects the zero bias current curve: The zero-base-current curve marks cutoff, the bias point of a Class B stage, not the mid-line point a Class A stage needs.