Amateur Extra Question E7B03
E7B: Amplifiers: class of operation; vacuum tube and solid-state circuits; distortion and intermodulation; spurious and parasitic suppression; switching-type amplifiers
What circuit is required at the output of an RF switching amplifier?
- A filter to remove harmonic content (correct answer)
- A high-pass filter to compensate for low gain at low frequencies
- A matched load resistor to prevent damage by switching transients
- A temperature compensating load resistor to improve linearity
Correct answer: A, A filter to remove harmonic content
Explanation
The devices in a switching amplifier produce a nearly square waveform, and a square wave is rich in harmonics. A low-pass or band-pass filter at the output removes those harmonics, so only the desired fundamental reaches the antenna. This keeps spurious emissions within limits. The filter is often built into the output matching network.
Why the other answers are wrong
- B, A high-pass filter to compensate for low gain at low frequencies: Low-frequency gain is not the problem; the unwanted harmonics lie above the operating frequency, and a high-pass filter would pass them.
- C, A matched load resistor to prevent damage by switching transients: A load resistor would turn output power into heat, defeating the efficiency that is the reason for using a switching amplifier.
- D, A temperature compensating load resistor to improve linearity: A switching amplifier is not linear to begin with, and a resistive load wastes power; the circuit actually needed is a harmonic filter.