Amateur Extra Question E9C05
E9C: Practical wire antennas; folded dipoles; phased arrays; effects of ground near antennas
What is the purpose of feeding an off-center-fed dipole (OCFD) between the center and one end instead of at the midpoint?
- To create a similar feed point impedance on multiple bands (correct answer)
- To suppress off-center lobes at higher frequencies
- To resonate the antenna across a wider range of frequencies
- To reduce common-mode current coupling on the feed line shield
Correct answer: A, To create a similar feed point impedance on multiple bands
Explanation
Moving the feed point off center, typically about one-third of the way from one end, puts it at a spot where the impedance is roughly the same, a few hundred ohms, on the fundamental and several harmonic bands. One feed point and a 4:1 balun can then serve multiple bands without a wide-range antenna tuner. A center feed is low impedance on odd harmonics but very high on even ones.
Why the other answers are wrong
- B, To suppress off-center lobes at higher frequencies: Offsetting the feed point does not suppress lobes; on higher bands an OCFD still develops the multi-lobed pattern of a long wire.
- C, To resonate the antenna across a wider range of frequencies: Resonance depends mainly on wire length, not on where the wire is fed; the offset feed is about matching impedance, not resonance.
- D, To reduce common-mode current coupling on the feed line shield: The asymmetric feed actually tends to increase common-mode current on the coax shield, which is why OCFDs usually need a good choke balun.