Amateur Extra Question E9C06
E9C: Practical wire antennas; folded dipoles; phased arrays; effects of ground near antennas
What is the effect of adding a terminating resistor to a rhombic or long-wire antenna?
- It reflects the standing waves on the antenna elements back to the transmitter
- It changes the radiation pattern from bidirectional to unidirectional (correct answer)
- It changes the radiation pattern from horizontal to vertical polarization
- It decreases the ground loss
Correct answer: B, It changes the radiation pattern from bidirectional to unidirectional
Explanation
Without a termination, the wave traveling down a rhombic or long wire reflects off the open far end, so radiation goes in both directions. A non-inductive resistor of several hundred ohms at the far end absorbs the forward wave instead. The antenna then carries a traveling wave rather than standing waves and radiates mainly toward the terminated end, giving a unidirectional pattern.
Why the other answers are wrong
- A, It reflects the standing waves on the antenna elements back to the transmitter: The resistor does the opposite: it absorbs the wave at the far end, so little energy is reflected back toward the transmitter.
- C, It changes the radiation pattern from horizontal to vertical polarization: Polarization depends on the orientation of the wires, and a resistor at the end does not change that orientation.
- D, It decreases the ground loss: The resistor dissipates power on purpose; it does nothing to reduce losses in the ground under the antenna.