General Question G4A09
G4A: Station configuration and operation
What is the purpose of delaying RF output after activating a transmitter’s keying line to an external amplifier?
- To prevent key clicks on CW
- To prevent transient overmodulation
- To allow time for the amplifier to switch the antenna between the transceiver and the amplifier output (correct answer)
- To allow time for the amplifier power supply to reach operating level
Correct answer: C, To allow time for the amplifier to switch the antenna between the transceiver and the amplifier output
Explanation
When the transceiver keys an external amplifier, the amplifier's T/R relay needs a few milliseconds to move the antenna connection. If RF arrives before the contacts close, the relay is hot-switched, which causes arcing, pitted contacts and possible damage. Many transceivers therefore offer an adjustable transmit delay.
Why the other answers are wrong
- A, To prevent key clicks on CW: Key clicks come from overly fast rise and fall times in the CW waveform, not from the timing of the amplifier keying line.
- B, To prevent transient overmodulation: Overmodulation is caused by excessive audio drive, not by T/R relay timing.
- D, To allow time for the amplifier power supply to reach operating level: The amplifier's power supply stays energized between transmissions; it does not power up each time you key.