General Question G4C02
G4C: Interference to consumer electronics; grounding and bonding
Which of the following could be a cause of interference covering a wide range of frequencies?
- Not using a balun or line isolator to feed balanced antennas
- Lack of rectification of the transmitter’s signal in power conductors
- Arcing at a poor electrical connection (correct answer)
- Using a balun to feed an unbalanced antenna
Correct answer: C, Arcing at a poor electrical connection
Explanation
An arc at a loose, corroded or poorly made electrical connection starts and stops very abruptly. Those sharp pulses are rich in harmonics and spread energy across a very wide spectrum, heard as broadband buzzing or crackling. Power-line hardware, worn switches and bad splices are common sources. Narrowband problems, by contrast, tend to sit on one frequency.
Why the other answers are wrong
- A, Not using a balun or line isolator to feed balanced antennas: Feeding a balanced antenna without a balun can put common-mode current on the feed line. That causes RFI on your own transmit frequency, not wideband noise.
- B, Lack of rectification of the transmitter’s signal in power conductors: It is rectification of RF (at bad junctions) that creates interference. A lack of rectification would not generate any broadband signals.
- D, Using a balun to feed an unbalanced antenna: A balun on an unbalanced antenna is a mismatch of method, at worst causing some loss or feed-line current. It does not generate broadband noise.