General Question G4D10
G4D: Speech processors; S meters; sideband operation near band edges
How close to the lower edge of a band’s phone segment should your displayed carrier frequency be when using 3 kHz wide LSB?
- At least 3 kHz above the edge of the segment (correct answer)
- At least 3 kHz below the edge of the segment
- At least 1 kHz below the edge of the segment
- At least 1 kHz above the edge of the segment
Correct answer: A, At least 3 kHz above the edge of the segment
Explanation
An LSB signal extends about 3 kHz below the displayed carrier frequency. To keep every part of the signal inside the phone segment, the displayed frequency must be at least 3 kHz above the lower edge. For example, if the segment starts at 7.125 MHz, set the radio no lower than 7.128 MHz.
Why the other answers are wrong
- B, At least 3 kHz below the edge of the segment: Setting the carrier below the edge would place the entire LSB signal outside the phone segment.
- C, At least 1 kHz below the edge of the segment: Any carrier setting below the edge puts the lower sideband out of the segment, regardless of the distance.
- D, At least 1 kHz above the edge of the segment: A 1 kHz margin is too small: about 2 kHz of a 3 kHz wide LSB signal would fall below the edge.