General Question G4E04
G4E: Mobile and portable HF stations; alternative energy source operation
Why should DC power for a 100-watt HF transceiver not be supplied by a vehicle’s auxiliary power socket?
- The socket is not wired with an RF-shielded power cable
- The socket’s wiring may be inadequate for the current drawn by the transceiver (correct answer)
- The DC polarity of the socket is reversed from the polarity of modern HF transceivers
- Drawing more than 50 watts from this socket could cause the engine to overheat
Correct answer: B, The socket’s wiring may be inadequate for the current drawn by the transceiver
Explanation
A vehicle's auxiliary (cigarette-lighter) socket is usually wired with light-gauge wire and fused at around 10-15 A. A 100 W transceiver can draw about 20 A on transmit. The result is excessive voltage drop, blown fuses or overheated wiring. For high-current loads, run heavy-gauge wire directly to the battery.
Why the other answers are wrong
- A, The socket is not wired with an RF-shielded power cable: RF shielding is not the issue; DC power leads are not normally shielded cable, and current capacity is the real limitation.
- C, The DC polarity of the socket is reversed from the polarity of modern HF transceivers: Vehicle sockets use a standard positive-center, negative-ground arrangement that matches transceivers; polarity is not inherently reversed.
- D, Drawing more than 50 watts from this socket could cause the engine to overheat: Drawing electrical power from a socket does not cause engine overheating; the risk is in the socket's wiring, not the engine.