General Question G4E10
G4E: Mobile and portable HF stations; alternative energy source operation
Why should a series diode be connected between a solar panel and a storage battery that is being charged by the panel?
- To prevent overload by regulating the charging voltage
- To prevent discharge of the battery through the panel during times of low or no illumination (correct answer)
- To limit the current flowing from the panel to a safe value
- To prevent damage to the battery due to excessive voltage at high illumination levels
Correct answer: B, To prevent discharge of the battery through the panel during times of low or no illumination
Explanation
When the panel's output falls below the battery voltage, at night or in heavy shade, current could flow backward from the battery through the panel and drain it. A series diode conducts only from panel to battery, so it blocks this reverse discharge. Regulating the charging voltage is a separate job for a charge controller.
Why the other answers are wrong
- A, To prevent overload by regulating the charging voltage: Voltage regulation is done by a charge controller; a series diode just passes current one way and does not regulate charging voltage.
- C, To limit the current flowing from the panel to a safe value: A diode does not set a safe current limit; current limiting depends on the panel's capability and any controller.
- D, To prevent damage to the battery due to excessive voltage at high illumination levels: Protection against overvoltage at high illumination needs a regulator; a blocking diode does not prevent excessive voltage.