General Question G9A06
G9A: Feed lines: characteristic impedance and attenuation; standing wave ratio (SWR) calculation, measurement, and effects; antenna feed point matching
In what units is RF feed line loss usually expressed?
- Ohms per 1,000 feet
- Decibels per 1,000 feet
- Ohms per 100 feet
- Decibels per 100 feet (correct answer)
Correct answer: D, Decibels per 100 feet
Explanation
Feed line loss is a power ratio, so it is given in decibels. Loss grows in proportion to length, so manufacturers state it per standard length, normally per 100 feet at a given frequency. For example, a 100 ft run of coax rated 1.5 dB/100 ft at 30 MHz loses 1.5 dB, and a 50 ft run loses 0.75 dB.
Why the other answers are wrong
- A, Ohms per 1,000 feet: Ohms measure resistance or impedance, not the ratio of power out to power in, and coax loss specs use 100 ft, not 1,000 ft, as the reference length.
- B, Decibels per 1,000 feet: Decibels is the right unit, but feed line attenuation is conventionally quoted per 100 feet, not per 1,000 feet.
- C, Ohms per 100 feet: Ohms describe impedance or resistance, such as 50-ohm coax, not loss; loss is a power ratio and is expressed in decibels.