General Question G9A07
G9A: Feed lines: characteristic impedance and attenuation; standing wave ratio (SWR) calculation, measurement, and effects; antenna feed point matching
What must be done to prevent standing waves on a feed line connected to an antenna?
- The antenna feed point must be at DC ground potential
- The feed line must be an odd number of electrical quarter wavelengths long
- The feed line must be an even number of physical half wavelengths long
- The antenna feed point impedance must be matched to the characteristic impedance of the feed line (correct answer)
Correct answer: D, The antenna feed point impedance must be matched to the characteristic impedance of the feed line
Explanation
Standing waves form when part of the forward wave reflects at the load and travels back. Reflection happens only when the load impedance differs from the line's characteristic impedance. If the antenna feed point impedance equals the line's impedance (for example 50 ohms to 50-ohm coax), the load absorbs all the power, nothing reflects, and the SWR is 1:1.
Why the other answers are wrong
- A, The antenna feed point must be at DC ground potential: DC grounding at the feed point is a lightning and static precaution; it has no bearing on whether RF reflects from an impedance mismatch.
- B, The feed line must be an odd number of electrical quarter wavelengths long: Changing the line length changes the impedance seen at the transmitter end, but the mismatch at the antenna, and so the standing waves, remain.
- C, The feed line must be an even number of physical half wavelengths long: A half-wave line only repeats the load impedance at its input; it doesn't remove reflections, and physical length ignores velocity factor anyway.