General Question G9A08
G9A: Feed lines: characteristic impedance and attenuation; standing wave ratio (SWR) calculation, measurement, and effects; antenna feed point matching
If the SWR on an antenna feed line is 5:1, and a matching network at the transmitter end of the feed line is adjusted to present a 1:1 SWR to the transmitter, what is the resulting SWR on the feed line?
- 1:1
- 5:1 (correct answer)
- Between 1:1 and 5:1 depending on the characteristic impedance of the line
- Between 1:1 and 5:1 depending on the reflected power at the transmitter
Correct answer: B, 5:1
Explanation
SWR on the feed line is set by the mismatch between the antenna and the line at the far end. A tuner at the transmitter end only transforms the impedance the transmitter sees, so the radio is happy at 1:1. Nothing changes at the antenna, so reflections still occur there and the line itself still runs at 5:1.
Why the other answers are wrong
- A, 1:1: 1:1 is only what the transmitter sees at the tuner's input; the tuner doesn't fix the mismatch at the antenna end of the line.
- C, Between 1:1 and 5:1 depending on the characteristic impedance of the line: The SWR is fixed at 5:1 by the antenna mismatch; the tuner's location means it cannot change conditions on the line between it and the antenna.
- D, Between 1:1 and 5:1 depending on the reflected power at the transmitter: Reflected power is a result of the line SWR, not a control on it; the tuner re-reflects it toward the antenna, but the line still shows 5:1.