General Question G9A11
G9A: Feed lines: characteristic impedance and attenuation; standing wave ratio (SWR) calculation, measurement, and effects; antenna feed point matching
What is the effect of transmission line loss on SWR measured at the input to the line?
- Higher loss reduces SWR measured at the input to the line (correct answer)
- Higher loss increases SWR measured at the input to the line
- Higher loss increases the accuracy of SWR measured at the input to the line
- Transmission line loss does not affect the SWR measurement
Correct answer: A, Higher loss reduces SWR measured at the input to the line
Explanation
Line loss weakens the forward wave on its way to the antenna. It weakens the reflected wave again on the trip back, so reflected power arriving at the input is much smaller. Less reflected power at the input means a lower measured SWR. A lossy line can therefore make a badly matched antenna look good, while the power is simply turning to heat.
Why the other answers are wrong
- B, Higher loss increases SWR measured at the input to the line: Loss attenuates the reflected wave, so it lowers, not raises, the SWR seen at the input; loss never creates extra reflection.
- C, Higher loss increases the accuracy of SWR measured at the input to the line: Loss masks the true antenna SWR, so the reading at the input becomes less representative of the load, not more accurate.
- D, Transmission line loss does not affect the SWR measurement: Loss does change the reading, because the reflected wave is attenuated over two trips along the line before it reaches the meter.