Technician Question T0A09
T0A: Power circuits and hazards: hazardous voltages, fuses and circuit breakers, grounding, electrical code compliance; Lightning protection; Battery safety
What should be done to all external ground rods or earth connections?
- Waterproof them with silicone caulk or electrical tape
- Keep them as far apart as possible
- Bond them together with heavy wire or conductive strap (correct answer)
- Tune them for resonance on the lowest frequency of operation
Correct answer: C, Bond them together with heavy wire or conductive strap
Explanation
All ground rods and ground connections must be bonded together with heavy wire or wide conductive strap so the whole system sits at one potential. During a lightning strike or power fault, separate grounds can differ by thousands of volts. That difference can drive damaging current through equipment, feed lines or people connected between them. Bonding turns many separate grounds into one low-impedance ground system.
Why the other answers are wrong
- A, Waterproof them with silicone caulk or electrical tape: Sealing with caulk or tape does nothing about voltage differences between separate grounds; connections need to be clean and tight, but bonding is the key step.
- B, Keep them as far apart as possible: Spreading rods apart without connecting them leaves each at a different potential during a surge; rods may be spaced out, but they must still be bonded together.
- D, Tune them for resonance on the lowest frequency of operation: A ground rod is a safety ground connection, not an antenna element, so tuning it for resonance has nothing to do with lightning or fault protection.