Technician Question T0B01
T0B: Antenna safety: tower safety and grounding, installing antennas, antenna supports
Which of the following is good practice when installing ground wires on a tower for lightning protection?
- Put a drip loop in the ground connection to prevent water damage to the ground system
- Make sure all ground wire bends are right angles
- Ensure that connections are short and direct (correct answer)
- All these choices are correct
Correct answer: C, Ensure that connections are short and direct
Explanation
A lightning strike is a very fast pulse with strong high-frequency content. Every extra foot of wire and every sharp bend adds inductance, which raises the conductor's impedance to that surge. Ground conductors should run as short, straight and direct as possible, with gentle, wide-radius bends where needed. That way the surge goes into the earth instead of arcing into equipment or the building.
Why the other answers are wrong
- A, Put a drip loop in the ground connection to prevent water damage to the ground system: Drip loops belong on feed lines at a building entry to shed water; in a ground conductor a loop adds inductance and impedes the lightning path.
- B, Make sure all ground wire bends are right angles: Sharp right-angle bends add inductance and invite arcing at the corner; lightning ground wires should use gradual, sweeping bends.
- D, All these choices are correct: Only short, direct connections is good practice; drip loops and right-angle bends both make a lightning ground less effective.