Technician Question T1B09
T1B: Frequency allocations; Emission modes; Spectrum sharing; Transmissions near band edges; Contacting the International Space Station; Power output
Why should you not set your transmit frequency to be exactly at the edge of an amateur band or sub-band?
- To allow for calibration error in the transmitter frequency display
- So that modulation sidebands do not extend beyond the band edge
- To allow for transmitter frequency drift
- All these choices are correct (correct answer)
Correct answer: D, All these choices are correct
Explanation
Section 97.307(b) requires your whole emission to stay inside the band or segment you're authorized to use. Leave a margin for three reasons. The frequency display may be slightly miscalibrated, and the transmitter can drift as it warms. Sidebands also extend beyond the displayed frequency: USB set to 28.500 MHz occupies about 28.500-28.503 MHz, beyond the Technician 10 m phone segment.
Why the other answers are wrong
- A, To allow for calibration error in the transmitter frequency display: True, since display calibration error can put you outside the band, but drift and sidebands are also valid reasons, so this alone is incomplete.
- B, So that modulation sidebands do not extend beyond the band edge: True, since sidebands occupy spectrum beyond the displayed frequency, but calibration error and drift are also valid reasons, so this alone is incomplete.
- C, To allow for transmitter frequency drift: True, since a drifting transmitter can wander past the edge, but calibration error and sidebands are also valid reasons, so this alone is incomplete.
Rules: §97.101(a), §97.301(a-e)