Technician Question T2B04
T2B: VHF/UHF operating practices: FM repeater, simplex, reverse splits; Access tones: CTCSS, DTMF; DMR operation; Resolving operating problems; Q signals
Which of the following could be the reason you are unable to access a repeater whose output you can hear?
- Improper transceiver offset
- You are using the wrong CTCSS tone
- You are using the wrong DCS code
- All these choices are correct (correct answer)
Correct answer: D, All these choices are correct
Explanation
Each listed setting can stop you from accessing a repeater even when you hear its output clearly. If your offset is wrong, you transmit on a frequency the repeater isn't listening to. If the repeater requires a CTCSS tone or a DCS code and you send the wrong one, or none, its receiver stays squelched. Check offset, tone and code first whenever a repeater won't respond.
Why the other answers are wrong
- A, Improper transceiver offset: A wrong offset does put you off the repeater's input, but a wrong CTCSS tone or DCS code can cause the same problem, so it isn't the only correct statement.
- B, You are using the wrong CTCSS tone: A wrong CTCSS tone does keep the repeater from opening, but offset and DCS errors can also block access, so this is true but not the complete answer.
- C, You are using the wrong DCS code: A wrong DCS code does keep a coded repeater closed, but offset and CTCSS mistakes are also possible causes, so this is true but not the only correct statement.