Technician Question T4A03
T4A: Station setup: connecting a microphone, RF power meter, a power source, a computer, digital equipment, an SWR meter; bonding; Mobile radio installation
Why are short, heavy-gauge wires used for a transceiver’s DC power connection?
- To minimize voltage drop when transmitting (correct answer)
- To provide a close match to the power supply output impedance
- To avoid RF interference
- To minimize radiative losses in the power cable
Correct answer: A, To minimize voltage drop when transmitting
Explanation
Every wire has some resistance, and a transceiver draws its highest current when transmitting, often 15-20 A for a 100 W rig. By Ohm's law the drop is V = I x R, so 20 A x 0.05 Ω = 1 V lost before the radio. Keeping the leads short and heavy-gauge lowers R, so the radio gets close to the full 13.8 V. Without that, transmit audio can distort or the rig can reset.
Why the other answers are wrong
- B, To provide a close match to the power supply output impedance: A DC supply has no output impedance to match like an RF feed line; the goal is low resistance, not an impedance match.
- C, To avoid RF interference: Wire gauge and length don't block RF pickup; interference is handled with ferrite chokes, bypassing and good bonding.
- D, To minimize radiative losses in the power cable: The DC cable carries direct current, which doesn't radiate; its loss is resistive heating that shows up as voltage drop.