Technician Question T4A04
T4A: Station setup: connecting a microphone, RF power meter, a power source, a computer, digital equipment, an SWR meter; bonding; Mobile radio installation
How are the audio input and output of a transceiver connected in a station configured to operate using FT8?
- To a computer running a terminal program and connected to a terminal node controller unit
- To the audio output and input of a computer running FT8 software (correct answer)
- To an FT8 conversion unit, a keyboard, and a computer monitor
- To a computer connected to the FT8converter.com website
Correct answer: B, To the audio output and input of a computer running FT8 software
Explanation
FT8 is a sound-card mode. The computer software turns the message into audio tones, and those tones feed the radio's audio input to be transmitted. The radio's receive audio goes back into the computer's audio input so the software can decode it. Many modern rigs do this through one USB cable with a built-in sound card, but it is still an audio-in/audio-out link to the FT8 program.
Why the other answers are wrong
- A, To a computer running a terminal program and connected to a terminal node controller unit: A terminal program with a TNC is the classic packet radio setup; FT8 needs no TNC, just software and a sound card.
- C, To an FT8 conversion unit, a keyboard, and a computer monitor: No separate FT8 conversion box exists; the decoding and encoding happen in software on the computer.
- D, To a computer connected to the FT8converter.com website: FT8 doesn't depend on a website; software such as WSJT-X runs locally and talks to the radio through audio.