Technician Question T7B11
T7B: Symptoms, causes, and cures of common transmitter and receiver problems: overload and overdrive, distortion, interference and consumer electronics, RF feedback
Which of the following can eliminate distorted voice transmissions?
- Adding extra feedline to the antenna to lower SWR
- Turning the radio on and off to reset the computer-controlled circuitry
- Adding a clip-on ferrite “choke” to the microphone cable to prevent the transmitted signal from feeding back into the transmitter (correct answer)
- Turning the squelch control fully clockwise to prevent the transmitted signal from triggering the squelch circuit
Correct answer: C, Adding a clip-on ferrite “choke” to the microphone cable to prevent the transmitted signal from feeding back into the transmitter
Explanation
RF from your own antenna can couple onto the microphone cable and feed back into the transmitter's audio circuits, distorting the voice signal. A clip-on ferrite choke presents high impedance to RF current on the cable's outside. This blocks the feedback path while the audio passes normally.
Why the other answers are wrong
- A, Adding extra feedline to the antenna to lower SWR: Extra feed line only adds loss that can mask a mismatch on the meter; it does not fix SWR or stop RF feedback.
- B, Turning the radio on and off to reset the computer-controlled circuitry: Power-cycling the radio does nothing about RF coupling into the microphone circuit, so the distortion returns at once.
- D, Turning the squelch control fully clockwise to prevent the transmitted signal from triggering the squelch circuit: Squelch only mutes the receiver when no signal is present; it has no effect on transmitted audio quality.