Technician Question T7C01
T7C: Antenna and transmission line measurements and troubleshooting: measuring SWR, effects of high SWR, causes of feed line failures; Basic coaxial cable characteristics; Use of dummy loads when testing
What is the primary purpose of a dummy load?
- To prevent transmitting signals over the air when making tests (correct answer)
- To prevent over-modulation of a transmitter
- To improve the efficiency of an antenna
- To improve the signal-to-noise ratio of a receiver
Correct answer: A, To prevent transmitting signals over the air when making tests
Explanation
A dummy load replaces the antenna and absorbs the transmitter's output as heat instead of radiating it. You can then adjust and test a transmitter at full power without putting a signal on the air. This avoids interference to other stations.
Why the other answers are wrong
- B, To prevent over-modulation of a transmitter: Over-modulation is controlled by audio level and mic gain, not by what load the transmitter feeds.
- C, To improve the efficiency of an antenna: A dummy load is used instead of the antenna and radiates almost nothing, so it cannot improve antenna efficiency.
- D, To improve the signal-to-noise ratio of a receiver: A dummy load is a transmitter test accessory and has no role in improving a receiver's signal-to-noise ratio.