Technician Question T7C02

T7C: Antenna and transmission line measurements and troubleshooting: measuring SWR, effects of high SWR, causes of feed line failures; Basic coaxial cable characteristics; Use of dummy loads when testing

Which of the following is used to determine if an antenna is resonant at the desired operating frequency?

  1. A VTVM
  2. An antenna analyzer (correct answer)
  3. A Q meter
  4. A frequency counter

Correct answer: B, An antenna analyzer

Explanation

An antenna analyzer contains a small signal source and measuring bridge. It sweeps or steps through frequencies and shows SWR, impedance and reactance. Resonance is where the reactance goes to zero, usually near the lowest SWR, so the analyzer shows directly whether the antenna is resonant where you want it.

Why the other answers are wrong

Previous: T7C01 · All Technician questions · Next: T7C03

Practice T7 Practical Circuits