Technician Question T7C03
T7C: Antenna and transmission line measurements and troubleshooting: measuring SWR, effects of high SWR, causes of feed line failures; Basic coaxial cable characteristics; Use of dummy loads when testing
What does a typical RF dummy load consist of?
- A low-voltage power supply and an AC relay
- A 50-ohm non-inductive resistor mounted on a heat sink (correct answer)
- A low-voltage power supply and a DC relay
- A 50-ohm inductive reactance mounted in a shielded enclosure
Correct answer: B, A 50-ohm non-inductive resistor mounted on a heat sink
Explanation
A dummy load must look like a perfect 50-ohm antenna, which means a pure resistance with no reactance. The resistor must therefore be non-inductive, and its value matches standard coax and transmitter outputs. All the RF power becomes heat, so the resistor is mounted on a heat sink, or sometimes immersed in oil, to dissipate it.
Why the other answers are wrong
- A, A low-voltage power supply and an AC relay: A power supply and AC relay switch circuits on and off; they cannot absorb RF power as a matched load.
- C, A low-voltage power supply and a DC relay: A power supply and DC relay also cannot absorb RF power as a matched load.
- D, A 50-ohm inductive reactance mounted in a shielded enclosure: A pure inductive reactance dissipates no power and presents a mismatch, so it would reflect RF energy back to the transmitter.